BULLETPROOF Block Spall 2Trauma Plate Level IIIA 11X14 Body Armor Vest ARMOR

  
BULLETPROOF INSERT soft inserts are. Stand-alone level IIIA Re Purposed vest plates PRICE is for 2- PLATE's, PLATE. The11"X14" soft insert are.

And milstd fragmentation rated construction. Great for handgun and frag protection in any plate carrier with 12"X14" pockets. And if worn in your IIIA vest they will stop all IIIA rounds as you will have IIIA armor behind level IIIA armor, plus 9mmAP, 7.62x25, 5.7x28.

50AE and other specialty pistol rounds and provide up to 40% blunt trauma reduction. Besides being light, about 13 ounces, these inserts are soft, flexible and comfortable and just over 1/4 thick. They are made of the best ballistics in the world; Kevlar. Goldflex with Spectra for really good stopping power for fragments and point blank shots such as. 44 magnum and are thinner and lighter than standard Kevlar. A mix of these 3 materials gives better protection than any single fabric insert. And these are perfect if you use plates in your plate carrier nearly all AR500 or Ceramic plates are in conjunction plates, meaning they have to have IIIA armor behind them to provide their rated protection. If "stand alone" isn't marked on your Ar500 or Ceramic plate then it needs soft armor behind it, and this includes military plates. Spall is when a bullet explodes into tiny fragments when hitting a steel plate at near a perpendicular degree angle.

Ricochet is when pieces, or even the whole bullet deflect off a steel plate when hitting at a sharper angle. These soft inserts are designed to go in your plate pockets IN FRONT of steel SAPI plates to mostly eliminate spall and reduce ricochets. They stop the bullet fragments exploding off after hitting the steel to keep them from hitting you or your nearby buddy.

Front plates are particularly dangerous because of being close to your carotid artery. All steel plates are prone to this problem, and rubber coatings (linex, rhinolining etc) do not do much after the 1st shot. And edge protection only stops spall from shots right at the edge, and can't stop richocets or high angle spall. The Level IIIA is a special threat armor package offering dual performance tested to the NIJ Standard-0101.04 and the FBI 2.0 Protocol.

357 SIG SPEER 125 go GDHP. 40 S&W SPEER 165 gr GDHP. 9MM GECO 124 gr FMJ. 9MM Sellier & Bellot 115 gr FMJ. 9MM Ranger 127 gr SXT HP.

9 mm FMJ at 1,400 fps (427 mps). 44 Magnum Semi-Jacketed Hollow Point at 1,400 fps (427 mps). The best for very high-risk situations to cover more of the uncommon or unusual threats. Minimizes blunt trauma injury to allow more effective return fire. To see just what old kevlar can do watch this video I found on youtube.

We shot an 11-Year-Old, Level II Vest with four, 9 mm rounds, plus'00' Buckshot, all from 24 (61 cm). The deepest penetration was 9 layers of Kevlar® - not even halfway through! The 9 mm bullets penetrated 5, 6, 8 and 9 layers - out of 20 layers total! Most of the'00' Buckshot is still on top of the vest.

These are manufactured by Armor dog body armor, a private company. They are NOT surplus, not improperly demilled. You also cannot be a felon. You also must agree that the use of this item will be for all legal reasons only. You understand that body armor is not bullet proof-IT IS ONLY BULLET RESISTANT, and if a bullet strikes you there is always a risk you will be injured or killed ; and.

Armor will fully cooperate with all criminal investigations. Non-law enforcement residents of Connecticut are prohibited from purchasing body armor. ALL WARRANTIES, INCLUDING THE WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY, ARE HEREBY EXCLUDED. Armor dog Armor does not cover any consequential damages, and its liability is limited to repairing or replacing defective items.