A stand alone armor plate with multiple hit capability Easily passed NIJ. 0.06 6 shot stand alone tests against 5.56 M855 M80 ball (greentip) and 5.56 XP193 55 Grain FMJ boattail. In house testing defeated 30-06 165 grain copper tip trophy. Base coat is fully encapsulated with 40 mils to protect against corrosion, chemicals and sweat. Optional Spall coat (build-up) is 225 mils.
20 thick on strike face. Fully tested by independent Lab to 6 shot stand alone tests against 5.56 M855 M80 ball (green tip) and 5.56 XP193 55 Grain FMJ boat tail. For front and/or back protection. Simply Stronger, Thinner and lighter that the competition. Our new proprietary ballistic steel core is far stronger than the AR500 AR650 steel core.This core is hardened all the way through unlike the AR500 AR650 which is only surfaced hardened. At only 0.197 inches thick nominal makes it 20% lighter than the AR500 and superior in strength. Our build-up spall coating is done with a Graco EXP-2 which is the top of the line high pressure heated coating system. Our plate core is chemically washed and etched on the strike surface to eliminate the coating from delaminating when shot which keeps the shrapnel from escaping from the armored assembly.
We utilize a CNC laser cutting table for the cutting of all our Armor products. There is no equal method. Plasma cutting cuts slowly, this puts a lot of heat into the steel. (Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening its edges.
The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods. Our Curved plate is formed on a custom laser cut die set with single radius bend on a custom built computer controlled hydraulic press guaranteeing a perfect formed plate each time.
Here at Tactical Scorpion Gear we manufacture our own vest carriers, Kevlar level IIIA vests and all our products. Weights : All weights are in pounds.
6 x6 : 2.1 6×8: 2.8 8×10: 4.4 10×12: 6.5 11×14: 8.7. Base coated with Super strong hybrid polyurea for the protection of the steel. Tested by HP White laboratory.This model complies with NIJ Standard-0101.06 for Ballistic Resistance of Body Armor. NIJ tested Level III+ Armor. Purchaser is encouraged to seek qualified legal counsel in his/her jurisdiction if Purchaser has any questions concerning ab federal, state, or local laws. 9 Although Sellers body armor is tested to withstand bullets, the armor is bullet resistant and not bulletproof. Body armor will not protect someone from injury or death in all circumstances. Body armor will not provide any protection for the parts not covered by the armor. Purchaser acknowledges that there is always a risk of injury, including serious injury or death, if struck by a bullet while wearing body armor. ALL WARRANTIES, INCLUDING THE WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY, ARE HEREBY EXCLUDED. These Terms and Conditions may be updated, revised, or changed without prior notice. The item "Tactical Scorpion Level III+ Body Armor Pair 10x12 Curved Lighter Than AR500" is in sale since Tuesday, October 4, 2016. This item is in the category "Sporting Goods\Hunting\Tactical & Duty Gear\Body Armor & Plates". The seller is "tacticalscorpiongear" and is located in Angier, North Carolina. This item can be shipped to United States.